VR Type 'A' Water Tower - 1c

VR Type 'A' Water Tower - 1c

This is a model of a VR Type 'A', all steel Water Tower with the higher capacity for the type, of 20,000 gallons. Although it is based on the official VR drawings for the Water Tower installed at Healesville Locomotive Depot, it is still suitable for use anywhere a tank of this design is suitable. This model is textured to represent a relatively ''older'' (slightly rusted) installation that was originally painted in the VR's Oxide Red scheme. These units were located throughout the state of Victoria and used primarily at smaller terminal locations and locomotive depots, where the larger 20,000 gallon, Type 'A' Towers (available separately by the same author) would have been ''inappropriate''. The model is intended for use in Trainz version TS2009 or later.

Author: Jerker

VR Type 'A' Water Tower - 1c
• $screenshot$.jpg 14.97KB
• concrete_cast-in-place_flat_grey-normals.texture.txt 61 bytes
• concrete_cast-in-place_flat_grey-normals.tga 256.02KB
• concrete_cast-in-place_flat_grey.texture.txt 53 bytes
• concrete_cast-in-place_flat_grey.tga 256.02KB
• config.txt 2.11KB
• dirty water-normals.texture.txt 40 bytes
• dirty water-normals.tga 1.00MB
• dirty water.texture.txt 32 bytes
• dirty water.tga 1.00MB
• large_round_steel_red-normals.texture.txt 50 bytes
• large_round_steel_red-normals.tga 2.00MB
• large_round_steel_red.texture.txt 42 bytes
• large_round_steel_red.tga 2.00MB
• tower.im 265.28KB

VE48: This asset uses an obsolete trainz-build number. Trainz-build numbers below 3.5 are no longer supported.
VE109: The low-detail meshes total more than 500 polygons. This may have a negative impact on performance: 0: 3552