CRB Dual Carriageway Road Bridge

CRB Dual Carriageway Road Bridge

This is a model of a Victorian (Australia) Country Roads Board Dual Carriageway Timber Road Bridge. This asset is provided as a Trainz kind ''track'' bridge, with ''end caps'' and is built to plans and designs used by the Board for such bridges throughout the state. Because this a 'spline', the bridge may be 'created' to any length and may, although examples in the real world were extremely rare, be used to create a curved bridge. As kind ''track', the asset has the ''isroad'' tag set to 'on', so that roads can be attached to either end allowing traffic to continue across the bridge if spawned by the attached road spline. Bear in mind, that as a ''dual carriageway'', the bridge is wide enough to accommodate two road vehicles, side by side, at any given time . This asset is intended for use in Trainz version TS2009 or later.

Author: Jerker

CRB Dual Carriageway Road Bridge
• $screenshot$.jpg 52.64KB
• bridge.im 89.18KB
• bridge_lod1.im 83.25KB
• config.txt 3.44KB
• endcap.im 76.20KB
• endcap1.im 63.69KB
• endcap1_lo.im 63.69KB
• endcap_lo.im 49.00KB
• stripped_bark-normals.texture.txt 69 bytes
• stripped_bark-normals.tga 1.50MB
• stripped_bark.texture.txt 36 bytes
• stripped_bark.tga 1.50MB
• wood_plank_painted_white.texture.txt 47 bytes
• wood_plank_painted_white.tga 769.04KB
• wood_plank_painted_yellow-normals.texture.txt 81 bytes
• wood_plank_painted_yellow-normals.tga 769.04KB